Looking for a sanity check … (waits for peanut gallery to quiet down)
Sangoma CRM module 16.0.10.19
I have webhooks enabled for both inbound and outbound calls, to fire on both start and end call events. However we are only seeing the start events. Is there any configuration to do other than selecting “start and end” in the GUI? How can I troubleshoot this module?
It’s been a long time since I have messed with that code but I believe it used to dump in to fwconsole dbug you should see a base64 string on each event
Thanks James. Interesting. I see the events and can base64-decode them to see the payload is for an end-of-call event, but these never get sent out.
Solved. It depends on CEL records, which I had disabled on this system:
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.