PBX Activated, but not Activated

[bksales]

I had this problem recently too. The fix for me was to change the ports via the command prompt

in putty get into mysql, then use the asterisk database, then change the lets encrypt port to something other than 80, then change the http port to 80. Once it’s activated you can change the ports back in the sys admin module.

Can't activate new PBX

Not sure what’s going on here but it’s been happening since yesterday. I tried to activate it, it goes through the normal steps, it says “Install Branding Updates”, and then kicks me out to a page saying the connection isn’t secure. It sends me to https://[IP address]:80 When I remove the port 80 and get back in it goes right back to trying to activate and I can’t get out of it. It recognizes that it’s been activated before and shows the Zend ID. If I click restart instead I get the same result…

See dicko’s comment at the end of the thread for the proper syntax, the forum strips some of the formatting. The word key needs the single back quote (next to the 1 on the keyboard) around it.