End Point Manager: Digium D80 now supported?

As per https://wiki.freepbx.org/display/FPG/EPM-Use+DPMA+for+Digium+Phones, I have:…

  • disabled module digium_phone aka “Digium Phones Config” in Module Admin
  • successfully enabled DPMA in EPM’s Global Settings
  • clicked on the new “DPMA Managment” link in the right navigator

only “DPMA Settings” does not show up, instead the upgrade page appears. What can be done?

That said, the second sentence in above article confuses me a bit:

Endpoint Manager commercial module will be responsible for configuring “DPMA” module for asterisk which will allow DPMA to push the phone/extensions configuration to respective phones.

Thanks and cheers,

fwconsole ma upgrade restapps --edge
fwconsole ma upgrade endpoint --edge

…tada!! "Settings > End Point Manager > DPMA Management > DPMA Settings” works

Case closed!

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.