Zaptel

FreePBX Installation / Upgrade
1

Hello,

I have recently upgraded my Freepbx, box by doing a complete reinstall with the latest ISO AsteriskNOWTM 1.7 32 bit

Everything is fine, except the POTS on my Digium board arn’t working.

dmesg suggests the Zaptel modules has not been installed…

Section from DMESG :-

dahdi: Telephony Interface Registered on major 196
dahdi: Version: 2.3.0.1
ACPI: PCI Interrupt 0000:03:01.0[A] -> GSI 16 (level, low) -> IRQ 169
wctdm24xxp 0000:03:01.0: Port 1: Installed – AUTO FXO (FCC mode)
wctdm24xxp 0000:03:01.0: Port 2: Installed – AUTO FXO (FCC mode)
wctdm24xxp 0000:03:01.0: Port 3: Installed – AUTO FXO (FCC mode)
wctdm24xxp 0000:03:01.0: Port 4: Installed – AUTO FXO (FCC mode)
wctdm24xxp 0000:03:01.0: VPM100: Not Present
dahdi_vpmadt032_loader: module license ‘Digium Commercial’ taints kernel.
dahdi_vpmadt032_loader: no version for “vpmadtreg_unregister” found: kernel tainted.
wctdm24xxp 0000:03:01.0: Booting VPMADT032
wctdm24xxp 0000:03:01.0: VPM present and operational (Firmware version 120)
wctdm24xxp 0000:03:01.0: Found a Wildcard TDM: Wildcard TDM410P (0 digital modules, 4 analog modules)
dahdi_transcode: Loaded.

Are Zaptel drivers included within the ISO, assuming so, why would the Digium board not receonised during the install process, and default drivers installed…Or am i looking in the wrong area ??

Thank you
Stephen

2

Zaptel is no more, it is called DAHDi now. And your card was found:

wctdm24xxp 0000:03:01.0: Found a Wildcard TDM: Wildcard TDM410P (0 digital modules, 4 analog modules)
3

Thank you for your reply…I was thinking the same…

OK so the card was found (and drivers have been instaled) yet calls in/out are not possible…“all Circuits are busy”

Is it possble to test my configuration to ensure drivers are loaded and working ??

Any advice on other areas to check would be appreciated

Thank you
Stephen