Skype Connect No Incoming Calls?

FreePBX Installation / Upgrade
1

Hi,

I have skype connect, I have been able to set up the SIP profile and I am able to make outgoing calls. I have to phones Cisco SPA504G they communicate fine with each other, so extensions are setup.

When I do an incoming call it rings twice than goes busy signal.

The CLI “core set verbose” thing gives me only these 4 lines

== Using SIP RTP TOS bits 184
== Using SIP RTP CoS mark 5
== Using SIP RTP TOS bits 184
== Using SIP RTP CoS mark 5

So as far as I can tell the call is making to asterisk and FreePBX but thats where it ends … the phones don’t ring.

Outgoing Settings:

Trunk Name: skype-out
PEER Details:
host=sip.skype.com
username=myskypeusername
fromuser=myskypeusername
type=peer
secret=mypass
dtmfmode=rfc2833
port=5060
context=from-trunk
canreinvite=no
insecure=invite,port

Incoming Settings:

USER Context: myskypeusername
USER Details:
username=myskypeusername
fromuser=myskypeusername
type=user
insecure=invite
host=sip.skype.com
fromdomain=sip.skype.com
secret=mypass
context=from-pstn
nat=yes
canreinvite=no

The Register Sting is setup ok because Skype confirms it.

The Inbound Route has no DID Number and is the to one of the extensions as a destination.

No incoming calls, I have searched and tried everything I could find for the past two days.

Thank You in Advance.

2

Have you found a solution?

3

Hello,
I have tried all king of configurations and in my Skype Sip Profile says that the registration is ok, but it is not fully true as my freepbx 2.10 sip info shows that the registration does no get through.

I have also tried your configuration with no results, the funny thing is that I use Linphone for test purposes and It registers OK I even get incoming calls

Did you have any issues with firewall or ports.

Thanks