Sangoma SBC Enterprise NIC config problem

Commercial Products and Partners Sangoma
1

Hi All

I have an oddity going on with NIC IP configuration in my virtual SBC. If I look at the network dropdown in the bar at the top of the gui it shows all the Eth items 0 to 3 (with Eth3 showing down). If I go to the IP set up and try to add Eth3 it is not in the drop down selection. If I go to the cli I can bring up the Eth3 by adding the ip address but I still cannot see it to make the change permanent in the GUI - what am I missing?

Thanks in advance.

2

It looks like this is the missing link:

https://wiki.freepbx.org/display/SBC/Adding+a+Network+Interface

Seems to solve my problem.

3

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.