Sangoma Appliance 40 new interface not responding

Commercial Products and Partners Sangoma
1

I just purchased a Sangoma Appliance 40. The local LAN is 192.168.1.0/24 the phones are on VLAN 192.168.100.0/24. On eth0 I set a static IP of 192.168.1.7 and I set eth1 to static 192.168.100.3. The eth1 interface will not respond to the phones or ping or anything. I whitelisted the both subnets in Intrusion Prevention and added the networks to the firewall for NAT. Any ideas why eth1 is not talking? It does not even show up on a LAN scan.

[root@freepbx ~]# clear
[root@freepbx ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth1
DEVICE=eth1
BOOTPROTO=static
ONBOOT=‘yes’
IPADDR=192.168.100.3
NETMASK=255.255.255.0
GATEWAY=192.168.100.1
ZONE=internal
PEERDNS=no
IPV6_PEERDNS=no
DESCRIPTION=“unset”

2

You need to get warranty support involved. If the interface isn’t showing up in the LAN scan, you have a problem we probably can’t help you with.

3

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.