I have recently found that BLF is not working on my system when using PJSIP. It works only until a reload (apply config) is performed and then the BLF light on the phone freezes. You can still press the button, but the light stays at whatever it was at before the reload. I am running Asterisk 13.2…

[image] BLF stops updating after "Apply Config" Endpoints Yes. No idea if it will help, but it should be disabled.

Was the “Allow transport reload” GUI option added in FPBX 14? I don’t have it on my 13 installs. Do you happen to know what the equivalent entry would be for that if I wanted to add it manually to a config file?

allow_reload=no in pjsip.transports_custom_post.conf did it. Great, thanks for the tip!

[image] avayax: allow_reload=no in pjsip.transports_custom_post.conf did it. This setting is already “no” by default. So I’d be a bit concerned that it required you to disable it.

[image] BlazeStudios: This setting is already “no” by default. No, not on my FreePBX 13 installs. There is no GUI option for that in Asterisk SIP settings and the default in all transports was allow_reload=yes, which I had to override in transports_custom_post.conf.

[image] avayax: No, not on my FreePBX 13 installs. That’s my point. In Asterisk many settings have a default value even it if is empty. If they are not set in the config, they still have a default value. In the case of allow_reload it is no. Which means the only way it can be set to “yes” is …

Wasn’t the default “yes” at some point? My guess is that my FPBX 13 system is from the time where this was still the case.

[image] avayax: Wasn’t the default “yes” at some point? Again, that is my point. It was default to yes in 13 and that was the wrong move to do because now while we can go in and just disable it in 14 or 15, you can’t. You have to go in and do custom configs to turn off a setting that shouldn’…

[image] avayax: My guess is that my FPBX 13 system is from the time where this was still the case Speaking of this that was still the case, is this still the case with HA? Specially the part about PJSIP? It’s recommended (but not required) that you install the Asterisk 11 distribution when …

[image] BlazeStudios: At this time PJSIP is not supported with HA and you will need to use chan_sip That’s no longer the case, they just forgot to update the wiki. Asterisk 13 and pjsip work fine with HA. Rob Thomas confirmed that to me in this thread: What would you like to see added in Fr…

As a result of the conversation in this thread, I opened a ticket to revisit the allow_reload setting for FreePBX generated transports. Core module ver. 13.0.131.9 (which is in edge now) now generates transports with it disabled by default: lgaetzdev2*CLI> pjsip show transport 0.0.0.0-udp Transpo…

PJSIP BLF freeze after reload

FreePBX Endpoints

lgaetz (Lorne Gaetz) December 22, 2019, 2:17pm 2