FreePBX | Register | Issues | Wiki | Portal | Support

Pattern for inbound route to avoid 1xxx-xxx-xxxx versus xxx-xxx-xxxx


(Jerry Warner) #1

I have two trunks active. One always puts a 1 on the front of the caller ID. The other does not. I’m using inbound CID Priority Routes. Is there a way to enter the CallerID Number so that it doesn’t care about any prefix numbers?

I’m currently entering each route twice. Once with the 1 and once without it. Just wondering if there’s a better way.


(Lorne Gaetz) #2

Set your trunks to context from-pstn-e164-us, it will normalize NANP CID to 10 digits.


(Jerry Warner) #3

I use SIPStation and the documentation says to only make changes via the Sipstation module. However there isn’t a place to change the peer details in the module. Does it break anything if I modify the trunk itself?


(system) closed #4

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.