Access to the Phone GUI
First you must go to Endpoint Manager → Brands → Sangoma → D & P Series Phones → " Select the template" → Options → Phone Built-in Web Access → Enable → Save, Rebuild, Update.
Enter the <phone_ip>
CLI
Factory Reset phone
- http://<phone_ip>/cgi-bin/phone_factory.cgi
How to take a screenshot of your phone’s display
- http://<phone_ip>/cgi-bin/screen_shot
Continuous view of your phone’s display
- http://<<phone_ip>/cgi-bin/screen_watch
Continuous view of your PM200 display
http://<phone_ip>/sidecar/0/cgi-bin/screen_watch
How to take a screenshot of your PM200 display
http://<phone_ip>/sidecar/0/cgi-bin/screen_shot
Note 0 = Sidecar 1 |1 = sidecar 2 etc
Thank you Sangoma
3 Likes
I don’t understand…wasn’t the cgi-bin stuff always part of the Digium D-series phones (since at least 2017)? What is new here?
On the Digium D65 you needed a password for the screenshot, it seems not anymore on the P-series phones…isn’t this a security issue?
Using DPMA to install phones blocked web access once the P-Series was connected. Not any longer.
Also you could not do a Factory Reset unless on-site and doing it through the phone display.
I just added the other stuff incase people were unaware of these options.
I see…so my P330 & P370 are connected in a non-standard way to freePBX. I somehow managed to use http instead of https. I dont want to open any ports for the certificate management. The phones work ok (the apps too, e.g. visual voicemail), but it seems there is no password requirement for the screenshot. Just tested it.