No RTP using single interface - SIP OK

Good morning! Greetings from Argentina.
We currently have 2 interfaces (ens32 & ens36, one for SIP, one for RTP) on the VM where the PBX is installed. We need to have all traffic going through a single interface.
When we tried this, there is no RTP traffic.
Does someone knows what to configure in order to achieve this?

You would have had to do something special for different interfaces to be used, so you basically need to undo that, or at least explain to us how your system is managing to route the two differently.

Also, key information here is which channel driver are you using?

This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.