No auth ids available?

[aqua]

I am getting this error when initiating a termination.

ERROR[248138] res_pjsip_outbound_authenticator_digest.c: Endpoint: 'channel1': There were no auth ids available

I am migrating to a different server and I was not getting any issues on my previous server. Trunk setup the same, not sure what the deal is.

[comtech]

@aqua

There were no auth ids available

There were no auth ids available on outbound call using a no registration pjsip trunk

The remote side challenged for authentication. Because none is configured, we couldn’t respond to their challenge.

[aqua]

But it is IP authentication. My other server with the exact same trunk configuration is working just fine. I’m thinking there is some other config that is not set right but I can’t figure out where.

[comtech]

Sounds pretty definitive. Are the signaling ports the same? Can you compare the config of each trunk? What are you trunking to? Have you checked the messages on the other side?