First time setting up a digital card for PRI’s and needing a little help. I have a Digium TE205P with echo cancellation. Here is my system.conf
Autogenerated by /usr/sbin/dahdi_genconf on Tue Oct 9 18:35:13 2012
If you edit this file and execute /usr/sbin/dahdi_genconf again,
your manual changes will be LOST.
Dahdi Configuration File
This file is parsed by the Dahdi Configurator, dahdi_cfg
Span 1: TE2/0/1 “T2XXP (PCI) Card 0 Span 1” B8ZS/ESF RED
Span 2: TE2/0/2 “T2XXP (PCI) Card 0 Span 2” (MASTER) B8ZS/ESF RED
and here is my chan_dahdi.conf
; Zapata telephony interface
; Configuration file
rxwink=300 ; Atlas seems to use long (250ms) winks
; Whether or not to do distinctive ring detection on FXO lines
"chan_dahdi.conf" 55L, 805C
With the pri’s plugged in I have a red flashing light on span 1 and a green light on span 2. Tried swapping the pri that was plugged in span 1 to span 2 to see if anything was different but was not. Light stayed flashing red on span 1 and green on span 2. When I looked at dahdi tools it showed alarm on span 1 and ok on span 2. Also, when you tried to call out you got all circuits are busy. Any help would be appreciated. Thanks!
Did not think to give version. Using FreePBX distro version 1.816.210