So, I’ve just installed the TE121 card and I’ve been googling everywhere to find out how to configure it. I’ve set up /etc/dadhi/system.conf correctly and it shows
[root@asterisk ~]# /usr/sbin/dahdi_scan
[1]
active=yes
alarms=OK
description=Wildcard TE121 Card 0
name=WCT1/0
manufacturer=Digium
devicetype=Wildcard TE121 with VPMADT032
location=PCI Bus 09 Slot 09
basechan=1
totchans=24
irq=98
type=digital-T1
syncsrc=0
lbo=0 db (CSU)/0-133 feet (DSX-1)
coding_opts=B8ZS,AMI
framing_opts=ESF,D4
coding=B8ZS
framing=ESF
I know coding and framing are correct because I changed them, rebooted the box and coding and framing then appeared blank. Also dadhi_tools showed the card as being unconfigured where as right now it shows ‘ok’. Also the LED turns green when the cable is plugged in. So I ‘think’ at this point I can say everything is working on a card level.
In asterisk
asterisk*CLI> dahdi show status
Description Alarms IRQ bpviol CRC4 Fra Codi Options LBO
Wildcard TE121 Card 0 OK 0 0 0 ESF B8ZS YEL 0 db (CSU)/0-133 feet (DSX-1)
asterisk*CLI> dahdi show channels
Chan Extension Context Language MOH Interpret Blocked State
pseudo default default In Service
1 from-pstn default In Service
2 from-pstn default In Service
3 from-pstn default In Service
4 from-pstn default In Service
5 from-pstn default In Service
6 from-pstn default In Service
7 from-pstn default In Service
8 from-pstn default In Service
9 from-pstn default In Service
10 from-pstn default In Service
11 from-pstn default In Service
12 from-pstn default In Service
13 from-pstn default In Service
14 from-pstn default In Service
15 from-pstn default In Service
16 from-pstn default In Service
17 from-pstn default In Service
18 from-pstn default In Service
19 from-pstn default In Service
20 from-pstn default In Service
21 from-pstn default In Service
22 from-pstn default In Service
23 from-pstn default In Service
So, it also appears to be correct. And last but not least, I had a default ANY/ANY under my inbound routes. And I g0 is the outbound trunk.
The problem here is I’m unable to receive incoming calls. All I get is a busy signal and asterisk never shows or see’s anything. And if I make an outbound call, it shows its using trunk g0, but just sits there and rings for-ever and never gets a connection.
I’m a but stumped. Anyone have any suggestions? Is there something simple I’m missing? I’ll post any other config files needed.
Thanks!