Free PBX SNG7-FPBX-64bit-2008-1 Cannot get past Linux boot

Hi All,
I am very new to FBX and am attempting to install it on a standalone machine (HP Elite Desk 800 g5).
I have downloaded the ISO and created VM to test and that works fine. However after copying ISO to a USB and then plugging into HP machine, Linux freezes

at this page (see attached image) and I cannot progress to even get to the FPBX installlation. I have tried many Bios settings such as disabling fastboot, disabling secure boot etc… to no avail.

Could it be a hardware compatibility issue?

Thanks in advance.

Did you check the md5sum of your downloaded iso image against the published one ?

Maybe reset your bios settings to factory just in case something is wrong with them?
When you say it freezes - do you mean it is happening as the linux installer is starting up or do you mean after the installation is done and is doing the first boot?

Yes I have and they are the same.

It’s related to the drivers.
You can test this: edit the grub file before starting the installation and add these:
noapic acpi=off

This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.