Cli no longer shows any information


#1

To investigate a problem with a phone, I started the cli and typed the standard :
sudo asterisk -r -vvv
it opens correctly but never shows any information. If I type a command (sip show peers, for example) it works well. But when I make a call, no information at all.
I rebooted (it has not been rebooted for three months !), no change.
“sip set debug on” does not change the problem.
I have never seen that, what could be the reason ?

FreePBX 15.0.16.38
Raspberry Pi 4, RAM 4 GB


(Joshua C. Colp) #2

#3

Thanks a lot for the information, this was the problem, everything was disabled.
But is it possible to find somewhere the recommended values for these settings ? Is everything on OK or is it too much ?


(Jared Busch) #4

If you don’t change any settings and update to current it will set defaults again.


#5

OK, thanks, It works.


(system) closed #6

This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.