Cli no longer shows any information

[dysmas]

To investigate a problem with a phone, I started the cli and typed the standard :
sudo asterisk -r -vvv
it opens correctly but never shows any information. If I type a command (sip show peers, for example) it works well. But when I make a call, no information at all.
I rebooted (it has not been rebooted for three months !), no change.
“sip set debug on” does not change the problem.
I have never seen that, what could be the reason ?

FreePBX 15.0.16.38
Raspberry Pi 4, RAM 4 GB

[jcolp (Joshua Colp)]

Bug in Asterisk Logfiles Module ver 15.0.4

Last week a security update was published for the Asterisk Logfiles module to resolve a cross site scripting vulnerability, version 15.0.4. Many (perhaps most) systems would have received the update and installed it automatically in the early morning of August 19. In addition to the XSS fix, there were improvements in logfiles browsing as well as updates on the way the logfiles are managed. Version 15.0.4 has a new bug that changed the default settings for the full log and console such that log…

[dysmas]

Thanks a lot for the information, this was the problem, everything was disabled.
But is it possible to find somewhere the recommended values for these settings ? Is everything on OK or is it too much ?

[sorvani (Jared Busch)]

If you don’t change any settings and update to current it will set defaults again.

[dysmas]

OK, thanks, It works.