Cisco VG224 Register Each Port to FreePBX Extension

I have a Cisco VG224 and a server running FreePBX. I would like to use the VG224 to register each analog port to an extension in FreePBX. I guess I effectively want a large ATA?

I’ve seen a few post alluding to it. They talk about doing so in this post: Issue registering old cisco device and a user gives another some instructions in this post: Use a Cisco router FXS as PBX subscriber - #7 by michelpy

I guess I just need a little more to get me over the finish line. Any ideas?

Howdy, welcome to the forums!

Depending on your FreePBX configuration, the integrated firewall might be detecting failed SIP registrations from your VG224 as attacks and automatically start blocking them.

What have you tried so far that is different than those posts ?

I use a Cisco 2800 with voice ports as a SIP trunk gateway. I never was able to get it to work on chan_pjsip but it works fine on chan_sip

Post your VG224 config and screenshots of how you have it setup in FreePBX.

This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.