Hi,
I have purchased a Digium TE110 E1 PRI PCI based card.
Installed it in a core i5 System and then installed FreePBX
I now have E1 PRI line from BSNL, India.
After going to the other tab of the FreePBX menu, I get the PRI card in recovery mode.
I have configured it as follows:
Alarms:REC
Framing/Coding:
Channels:31/31 (E1)
Signalling:PRI-CPE
Switchtype:National ISDN
Sync/Clock Source:0
Line Build Out:0
Pridialplan:UnKnown
Prilocaldialplan:UnKnown
Group: 0
Context: incoming
Channels:31
From: 1-15,17-31 Reserved: 16
Now I have to make sure that I would be able to do incoming calls.
Do I need to do any further steps than this?
Regards,
Piyush