Have a Freepbx 15 up and running. Whenever I try to apply configuration it is painfully slow(up to 5 minutes) It usually completes but there are times where it says couldnt do it try fwconsole verbose etc… I am not sure where to go with this except to the best that are in this forum. I am a relati…

I’ve noticed a slower apply config in general in v15. I’ve had some success removing some modules in Module Admin that don’t get used, but it’s still slower than previous versions.

Try changing: Settings -> Advanced Settings -> Enable Module Signature Checking to ‘No’. It will be changed back to ‘Yes’ each time new modules are installed. If this solves your problem, the following script can be used instead of Module Admin to upgrade modules without incurring long reload ti…

[image] yogutt: Have a Freepbx 15 up and running. Distro or did you install the softwre yourself?

[image] Apply config taking forever and not working Configuration I recently upgraded to 15 Now when I try to apply config it can take up tp 10 minutes and then tell e it failed. Looking around on some help sites they said to disable signature checking I tried fwconsole…

I will try that now but just tried an apply config before I read this and got this error There was an error during reload: Unknown Error. Please Run: fwconsole reload --verbose Any Ideas Yosef Guttman

Also didn’t help seems to be taking upwards of 5 minutes and still not always working

[image] yogutt: Any Ideas Yes but you will have to actually do some troubleshooting work, as already suggested. Earlier I asked whether this is a Distro or you installed FreePBX yourself. Please answer that. What is the output when you run the reload at the command line with the verbose opt…

[quote=“billsimon, post:8, topic:76345”] Yes but you will have to actually do some troubleshooting work, as already suggested. I AM TRYING BUT JUST NOT THAT GOOD AT LINUX PROGRAMMING AND NOT SURE WHAT I AM LOOKING FOR Earlier I asked whether this is a Distro or you installed FreePBX yourself. Ple…

[image] yogutt: HOW DO I RUN IT I TRIED JUST TYPING PS AX ON THE LINUX SCREEN GOT AN ERROR You have to type it in lower case…

You’re right here is the response from the command after hitting apply config PID TTY STAT TIME COMMAND 1 ? Ss 64:08 /usr/lib/systemd/systemd --switched-root --system --deserialize 22 2 ? S 0:01 [kthreadd] 4 ? S< 0:00 [kworker/0:0H] 6 ? S 5:5…

Apply Configuration SLLLLOOWWWWW!

FreePBX System Administration

jfinstrom (James Finstrom) June 22, 2021, 8:46pm 5

Participating in your own troubleshooting is key