Zap trunk dialing to fast into old PBX?

General Help
1

First off everything is working smoothly except this little issue. Thanks for this great software! Love the new look too. :slight_smile: Now I have a Digium TDM808B card (total pain to setup but works flawlessly once configured) that has two phone lines and 6 other lines to an old PBX. I can dial 3 digit extensions into the old system with no problems. When I have FreePBX dial 9 to get an outside line though the old PBX it dials the remaining digits too quickly. This results in a bad dial. Is there an easy way to add a wait once 9 is dialed in FreePBX? Or will I need to edit a config file? Anyone point me in the right direction?

Thanks,
A.J.

2

Solved. After mousing over Outbound Dial Prefix I noticed you could use a w to wait. I added this to my dial rule (9w1+NXXNXXXXXX) and now it dials out normally! If only this was mentioned in the dial rules info as well. Ooops.

A.J.