in queue and bounce messages

New freepbx15 setup. In the mailqueue I’m seeing message trying to be sent to [email protected] that are fail2ban alerts. I have fail2ban configured in sysadmin pro with the correct email addresses. I also have checked jail.conf configuration via the cli, not seeing anywhere that this address would be configured.

admin > sys admin > notifications ??

Unfortunately that was the first place I looked :slight_smile: I also cleared it out, submitted, reconfigured and submitted again just to make sure we were all good there.

Check intrusion detection and ensure you have an email address set for those alerts.

This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.