Wanpipe1.conf always set to CCS when CAS is selected

We have Freepbx 16 with a Sangoma A101 card in E1 MFC/R2 mode. Framing/Coding is set to CAS/HDB3 from the DAHDI Config module. For some reason when wanpipe1.conf is built automatically on a “fwconsole start” I can see that “TE_SIG_MODE = CCS” and not CAS as it should be. I cannot find any setting anywhere to change that to CAS and if I change the file by hand it will revert to CCS on the next restart. Anyone know where Freepbx gets this value to build wanpipe1.conf?

This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.