VM Notify Endless Retry

Hi,

I was wondering if there’s a way to have the VM Notify go into an endless mode. In most of the scenarios we are looking at implementing for are mostly single practitioner doctor’s offices, where a single person is on call. Calling every 15 minutes, with a retry count of 10 (max) would only try calling for two and a half-hours. (Yes, I realize that this would not be a very good on call doctor, but it could also be used for building maintenance, plumbers, etc.)

As I type this, I am thinking that we could setup the same number with different priorities and then set the retry to 10, the priority delay to the same as the retry, and this should multiply the length based on how many numbers with priority are given?

Thanks,
Carlos.

1 Like