Upgraded to 2.10 but now DID not reconized?

FreePBX Installation / Upgrade
1

Okay I upgraded to 2.10 with no errors except now DID are not being recognized I had to change to a ‘blank’ on of the routes in order to get at least one line working. No outbound lines are working. Is there some special way to represent the DID in a route. Do I need a ‘1’ in front of the number?? I am using just the full 10 digit number no spaces, hyphens or brackets am I supposed to use something else here???

Thanks

Centos 5.8
Asterisk 1.8.12.1

2

See above post problem was my group definitions being over ridden by using the #include dahd-channels.conf which had different group numbers from what I assigned.