Upgrade 6.12.65 to 10.13.66

1

Hi all.
The pots isn’t a complain is juts to show what happened when I tryed to upgrade (distro) from 6.12.65 to 10.13.66 using distro and working with Putty. Maybe this can help others users.

Your FreePBX Distro System is being upgraded to 10.13.66-1. Please standby…

STAGE 1 STARTING - GUI Modules

Machine not activated

Upgrade All FreePBX GUI Modules

Fetching FreePBX settings with gen_amp_conf.php…

Fetching FreePBX settings with gen_amp_conf.php…

PHP Fatal error: Uncaught exception ‘Exception’ with message ‘Unable to locatethe FreePBX BMO Class ‘Userman’A required module might be disabled or uninstalld. Recommended steps (run from the CLI): 1) amportal a ma install userman 2) amortal a ma enable userman’ in /var/www/html/admin/libraries/BMO/Self_Helper.clas.php:205
Stack trace:
#0 /var/www/html/admin/libraries/BMO/Self_Helper.class.php(100): Self_Helper->ladObject(‘Userman’)
#1 /var/www/html/admin/libraries/BMO/Self_Helper.class.php(36): Self_Helper->auoLoad(‘Userman’)
#2 /var/www/html/admin/modules/userman/functions.inc.php(6): Self_Helper->__get’Userman’)
#3 /var/www/html/admin/modules/cxpanel/functions.inc.php(54): setup_userman()
#4 /var/www/html/admin/bootstrap.php(212): require_once(’/var/www/html/a…’)
#5 /etc/freepbx.conf(9): require_once(’/var/www/html/a…’)
#6 /var/lib/asterisk/bin/module_admin(15): include_once(’/etc/freepbx.co…’)
#7 {main}
thrown in /var/www/html/admin/libraries/BMO/Self_Helper.class.php on line 205
Error: fwconsole not correctly installed. Please run reload manually
Machine not activated
Machine not activated

have all the procedure but I just put here one little part I think that all you will understand what happens. _
after that the system continues to say that I have version 6.12.65. and I was not not able to get in the gui.

Thats it.

2

User Manager module failed to install:

fwconsole ma install userman
3

Hi,
Thank you very much for your attention time and your answer, but…
Yes this option - fwconsole ma install userman - could solve the problem but not in my case as when you write fwconsole you get nothing, I tryed to find where fwconsole could be in my computer but the answer is that I do not have the fwconsole in it, even the directory that it suppose to be I even do not have, so I made some mistake most likely in the upgrade process or this is something that allways happens when you try to upgrade from 6-12-65-to-10-13-6 using a terminal, in my case I was using Putty.

Another problem (just to - maybe - help others users as I’m a newbee in Freepbx) is that the computer that I was using -Vmware - had a too small configuration to do the upgrade - 1gb ram - 10gb hard disk.
Anyway I read here in forum that to do the upgrade it will be better to use the Gui console and can take about 3 hours but works.
Thats it
Thanks again