TWO Patton to 1 FreePBX

FreePBX Installation / Upgrade
1

Hi,
is it possible to connect two Patton (with different IP Address) to the same FreePBX System using the UDP Port 5060?

E1/PRI - (Patton 1, IP xxx.xxx.xxx.001) - Port 5060 <> FreePBX System
E1/PRI - (Patton 2, IP xxx.xxx.xxx.002) - Port 5060 <> FreePBX System

Is it a valid configuration? or do I need to change the UDP Port?

Thanks for your support.

2

The IP addresses are different, so there is no problem using the same port. Set them up as separate trunks.

3

Hi @Stewart1,
thanks for your answer.

Kind Regards

4

This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.