Freepbx distro 5.211.65-12
Sangoma A400 with 12 fxo
Card was in the system when the distro was loaded. Dahdi has been enabled in modules and enabled Dahdi write. Sangoma settings are available in the Dahdi config so it did see the card.
However there are no FXO ports listed under the analog card hardware.
Is the setup of the card not all done within freepbx? Or should it be done outside of freepbx with the sangoma utilities?
Based on the Dahdi config docs on the wiki, it appears all should be done inside the freepbx gui
.