Problem with X100P

FreePBX Installation / Upgrade
1

I have installed two X100P cards.
In trunk tab i have configured this way.
ZAP G0 / maximun channels = 1
ZAP G1 / maximun channels = 1

my etc/zaptel.conf is

Span 1: WCFXO/0 “Generic Clone Board 1” RED

fxsks=1

Span 2: WCFXO/1 “Generic Clone Board 2”

fxsks=2

Global data

loadzone = us
defaultzone = us

When i type lszaptel shows.

Span 1: WCFXO/0 “Generic Clone Board 1” RED

1 FXS FXSKS (In use)

Span 2: WCFXO/1 “Generic Clone Board 2”

2 FXS FXSKS

When i type ztcfg -vvvv shows

Zaptel Version: 1.4.6
Echo Canceller: OSLEC
Configuration

Channel map:

Channel 01: FXS Kewlstart (Default) (Slaves: 01)
Channel 02: FXS Kewlstart (Default) (Slaves: 02)

can´t receive calls from Zap/g0 or Zap/g1

I need help… Thanks…

2

Did you create a zap DID in FreePBX and the required inbound route?

3

fixar, so that you know x100 boards are highly un-reliable.

you need to provide more info. are they on there own irq? if not they should be as any other device sharing the IRQ will cause problems.

Did you run genzaptelconf?
This a hand built system or a distro? If so which one and exactly which version as some have issues.