FreePBX | Register | Issues | Wiki | Portal | Support

Polling and status


(Luke Wilcox) #1

I just installed M3 and connected it to my test PBX 12 box here. I shows status as unknown and hasn’t polled since I installed connected the two. I even shut off my test server for about 20 minutes to see if I would get an alert, but no go.

I do get this in the logs:
fatal: [xxx.xxx.xxx.xxx] => SSH Error: data could not be sent to the remote host.
Make sure this host can be reached over ssh

I can ssh from the M3 server to the PBX. Is this something is is still being worked on or is there something that I missed when following the wiki?