PJsip Multiple Contacts - Becomes Unavailable

Hello,

I have a pjsip extension that I set up on a Polycom IP650 desk phone and one Yealink W60B cordless phone.

But devices register and are able to place outgoing calls, however the incoming calls will only go to one device.

When both devices boot both of them register and show as available in the peers, after approximately 30 seconds the peer of the polycom is lost and shows as unavailable

90% of VoIP issues end up being network issues. Basically, what I am saying is that it is probably an issue with the network. Please follow this guide to make sure your network is setup correctly: https://wiki.freepbx.org/display/FPG/NAT+Configuration+FreePBX+12

What I just tried and looks like working for now is increasing max contacts to 4 instead of the 2 I use to make room for dormant registrations

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.