PJSIP All circuits busy

Hello,

After some time tinkering around I have PJSIP working with Voip.MS. However, I am experiencing an issue when I dial out to any one of my DID’s from an internal extension.

If i place an outgoing call from any extension to a DID i have an incoming route for I get “all circuits are busy”.

Example.
So, if ext 100 has and incoming route for 111-111-1111

From Extension 101 I can only dial “100”. If I dial 111-111-1111 it will give me an “all circuits are busy now”

Everyone is busy/congested at this time (1:0/1/0)
== Spawn extension (restrictedroute-c4ca4238a0b923820dcc509a6f75849b, h, 1) exited non-zero on ‘PJSIP/100-00000006’

Thank you! I appreciate any help!

You have the module “Extension Routes” enabled but not configured. Either disabled it or uninstall it or correctly configure it.

Sorry, I should have mentioned that I can call out to any other number just fine.

Disabled extension routes and it is still giving me “all circuits are busy” when i dial one of my voipms DID’s.

I do have the context as from-trunk. Is this right for voipms and pjsip?

I just tried dialing another number in my voipms account that is just registered to a sip phone and is not in use on my voipms sub account. I get the same thing. Its weird. This could be a voipms problem.

Now that you disabled extension routes it’s impossible for you to have the same error. So please post the new errors.

= Everyone is busy/congested at this time (1:0/1/0)
[2016-10-01 09:48:56] WARNING[29256][C-0000000e]: channel.c:4910 ast_prod: Prodd ing channel ‘PJSIP/100-0000001c’ failed
== Spawn extension (macro-outisbusy, s, 5) exited non-zero on ‘PJSIP/100-00000 01c’ in macro ‘outisbusy’
== Spawn extension (from-internal, 2011770, 7) exited non-zero on ‘PJSIP/100-0 000001c’
== Spawn extension (macro-hangupcall, s, 4) exited non-zero on ‘PJSIP/100-0000 001c’ in macro ‘hangupcall’
== Spawn extension (from-internal, h, 1) exited non-zero on ‘PJSIP/100-0000001 c’

Thanks for your help

TM1000. The issue was I had my voipms account number in “from user” on the pjsip trunk settings. I looked in my voip.ms CDR and the caller id was my account number. When i left “from user” blank it passed a 10 digit caller id. Thanks for your help.!