Newbie: Cant reach the IVR

I have AsteriskNow 1.5 installed with FreePbx GUI 2.5

I followed the instructions here(http://www.freepbx.org/support/documentation/administration-guide/creating-an-ivr) to create and configure my IVR.
Then I downloaded and manually setup miscapps-2.5.0.4.tgz in order to test it. But as i dial the *5(the feature code i assigned to my Misc Application) the SJphone pops the error up (Number does not exist. Call rejected: 404 Not Found).

In Feature Code menu I see my just created code *5 and its status is Enabled.

What am i do wrong?

best regards.

First… I am but a tadpole and you should take everything I say with a grain of salt. I did write a manual based on what I have done so far though.

I just followed the instrustions in piaf without tears.

It says to test it with 7777.

Did you set up a Digital Receptionist Route?

Hope that helps.