Thanks for the response and here is a bit of further clarification:
We were actually converting a few running servers over to a new data-center and decided to do clean installs and Asterisk upgrades at the same time and just manually rebuild everything from scratch. Since we were going that route we figured we would also try PJSIP.
We carefully mirrored every setting from the working servers to the new servers and when we thought everything was ready we did an after hrs cut.
We had three issues hit us immediately:
- No outbound calls
- Couldn’t “see” the any phones in the Admin Restart Phones section (picture below)
- Our logs were overwhelmed with error messages and were almost useless due to the repeated errors and the volume
We cut back to the old servers and afterwards found the answer to problem 1. The trunks in our working servers had username=xxxxx in the peers details section but the new servers also needed fromuser=xxxxx once we did that the outbound calls were working
Item 2 we never figured out:
Item 3 we never figured out but were are currently working on it:
http://issues.freepbx.org/browse/FREEPBX-8986
For the time being we cut all the servers back to Channel SIP