I’m trying to learn how to setup and use PBX in a home server environment. I have the server set up, and am registered with Anveo Direct, however I can’t find a good guide that’s less than 10 years old how to get it set up.
I’d like to have a couple of numbers coming in to one extension, allow outbound calls, and record calls.
Can someone point me in the right direction?
I’m on FreePBX 17.0.19.12
Does the trunk show as Available in Reports → Asterisk Info → Peers?
If not, confirm that in Asterisk SIP Settings, Local Networks and External Address are correctly set (restart Asterisk if you change these) and for the trunk you have:
Authentication: None
Registration: None
SIP Server: sbc.anveo.com
Match (Permit): (list of addresses from which Anveo can send calls)
If trunk is available, turn on pjsip logger, make a failing outgoing call, paste the Asterisk log for the call at pastebin.com and post the link here.
Likewise for incoming.
Thank you.
I think I’m even more beginner than that. Any info on how to configure on both the Anveo and FreePBX side?