First settings after installaton

FreePBX Installation / Upgrade
1

Hi,
I just installed AsteriskNOW with FreePBX Administrator.

Step SET A STATIC IP ADDRESS AND CONFIGURE DNS and first problem.
Here http://www.freepbx.org/support/documentation/installation/first-steps-after-installation says Click Tools. But I have not this Tools

I have that:
Admin - Digium Addons (disabled)
- Administrators
- Custom Destinations
- Custom Extensions
- Features Codes
- FreePBX Support
- Module Admin
- System Recordings
Applications -
Connectivity - Digium Phones
- Inbound Routes
- Outbound Routes
- Trunks
- Zap Channel DIDs
Reports - CDR Reports
- FreePBX System Status
Settings - Advanced Settings
- General Settings
- Music On Hold
- Voicemail Admin
Other -
Apply Config

Logout - Language

No Tools item. How to do for to set parameters ?

2

Note that these instruction are for Versions 2.9 and 2.10 Asterisknow installs an older version, I think 2.7.

You have to configure the IP manually.

http://www.how2centos.com/centos-configure-network/

3

The new AsteriskNOW uses 2.10. The “First Steps” mentions that 2.10 has a different layout.

The real problem is that the new AsteriskNOW includes almost NONE of the FreePBX Modules. You have to use Module Admin to download almost everything, and once that’s done, a bunch of stuff gets broken too.

Moral of the story: Don’t use AsteriskNOW.

4

Good new information. My guess is wrong PHP version. They certainly don’t take a lot of time tuning it. The problem is they make an rpm without scripting install_amp. Now that all the settings are in the DB nothing gets exported properly.