Delay on ring

I have a delay when the system is ringing. I currently have the old pbx system in operations with the new one. The old one rings as it should but the Asterisk system takes an additional 6 seconds before it starts to ring. If you answer the old system it takes 6 seconds for the new system to catch up. Here is the line in the log

[2012-05-02 12:50:12] VERBOSE[27442] sig_analog.c: – Starting simple switch on ‘DAHDI/2-1’
[2012-05-02 12:50:18] VERBOSE[27442] pbx.c: – Executing [[email protected]:1] NoOp(“DAHDI/2-1”, "Entering from-dahdi with DID == ") in new stack

After this everything happens as it should.

Any thoughts how to reduce the delay?

I think that if you have an analogue line the system waits for the calling line ID which comes “I believe” after the first ring, then it starts to ring your phones.

you can turn off CLI in the config file.

hope this helps