Day/night module...I don't understand

General Help
1

I’m having a hard time understanding the new day night module and how to make it work.
I need to have the receptionist dial *280 to switch from the time condition from 9am-5pm that rings her phone for 15 seconds then goes to the DayIVR.

When I dial *280 it says it goes to night mode which is set to go straight to the dayIRV.
But when I test its still following the existing Time condition and ignoring the night mode destination?

Any Suggestions?

This is pbxinaflash with Asterisk 1.4

2

Have you looked at the documentation on this site? There is also a write up on using it with time conditions at the bottom of the module documentation under Related Content.