Day / Night Mode Control

Hello everybody.
I am using FreePBX
I would like to use more than one day/night control. I need to use different day/night codes to forward muy unique Inbound Route called Any DID/any CID. Is it possible?

But in the Set Destination section, of this inbound route, I can only choose ONE destination, in this case, only one day/night mode.

For example, “nightA”. So, I can only set on or off this “nightA” by its feature code. But I need to configure differentes day/night like “nightB”, “nightC”, because I need to forward my “main line” to differentes extensions depending to where room is going to use the man who works at night.

Any ideas to solve that?
Thank you very much!