Cisco Cube as a new sip trunk

General Help
1

Hello,

I will have to configure a new sip trunk to my freepbx. My sip provider will install a Cisco Cube in my LAN.

There is no problem tu configure a new sip trunk, but I need to confirm some parameters in my freepbx.

Where can I confirm these parameters in my pbx?:·
Min-SE header = 7200·
DTMF in-band

Is it possible to confirm this values from my
graphic interface?, or do I have to use commands?

Thanks in advance

2

Hello again, I have it working in one direction, outgoing.
But I have troubles with the incoming route.
Any help with PEER DETAILS and USER DETAILS?

Incoming: When I call to that number, it is answered automatically…in silence, but I can’t reach the Destination I have configured in the incoming route (an Extension, just to test).
Any help?
Thanks.

3

What asterisk cli shows you, does the call reach asterisk or is it being answered from the cube?

4

Everything was ok, after some tests. Sorry for the delay.