Hi,
On freepbx (GUI), whatever reason number fails we always get ‘all circuits are busy’ audio.
Does anybody know how to get far end audio when we dial wrong number or when it’s busy or unallocated number or failed with some other reason.
Thanks,
Deepika
Any suggestions on this post please ?
This feature was added in FreePBX 2.8 together with the module Route Congestion Messages
The following are detected:
No Answer
Message or ToneMessage or tone to be played if there was no answer. Default message is: “The number is not answering.” Hangupcause is 18 or 19
Number or Address Incomplete
Message or tone to be played if trunk reports Number or Address Incomplete. Usually this means that the number you have dialed is to short. Default message is: “The number you have dialed is not in service. Please check the number and try again.” Hangupcause is 28
Unallocated Number
Message or tone to be played if trunk reports Unallocated Number. Usually this means that the number dialed does not exist. Default message is: “The number you have dialed is not in service. Please check the number and try again.” Hangupcause is 1