[quote] Rob, Diego,
ÃÂ
How about the following suggestion:
ÃÂ
Add something to general (or appropriate module) that let’s the user select the IP address (and the rest of the message for that matter) - in which case you are probably talking a voicemail module, where you can also set voicemail defaults, formats, etc. You can create a menu out of the available addresses as well as let them have a write in for the address. If they never set anything up - you can just use a default message like "go get on your admin’s case for not setting anything up as you can’t get to your email until they do:)"
ÃÂ
p
–––
Message: 8
Date: Tue, 02 May 2006 10:29:00 +0300
From: Diego Iastrubni
To: [email protected]
Subject: Re: [Amportal-devel] [FreePBX] #760: Linux specific: apply_conf.sh
Reply-To: [email protected]
Nice idea, would you like to implement? 
Rob Thomas wrote:
[quote]Except for the fact that my eth0 is 0.0.0.0, my eth1 is 192.168.1.1, and
my ppp0 is 203.whatevermyipaddressis.
I probably need to do something about check what interface the default
route is on, then do an ifconfig and grab the IP address of that (as
it’s pretty likely that the interface that the default route is on will
have a valid IP address)
–Rob
[/quote]
[/quote]
Yahoo! Messenger with Voice. PC-to-Phone calls for ridiculously low rates.
Post generated using Mail2Forum (http://www.mail2forum.com)