Do you still have internet connectivity to the FreePBX mirror servers? Are/were you using an http proxy? The error about unable to parse XML response from the mirror is interesting.
looks like that is working, but i still think asterisk will have the same problem starting & will fail
will know when it is finished - thanks
the upgradeall finished
i can now log into the GUI and see all my modules
however i lost my paid sysadmin module - looking for credentials to get it back
asterisk still not running
same errors as in my 1st post when i run ‘asterisk -rv’
fwconsole restart
…
Running Asterisk pre from Ucp module
UCP Mode Server is not running
in php-asmamanger.php line 495:
fclose() expects parameter 1 to be resource, bool given
My upgrade also had trouble starting asterisk. In my case, it was complaining missing extconfig_custom.conf
So I did
touch /etc/asterisk/extconfig_custom.conf
It fixed the problem. .
that fixed it - thanks
now just my admin module to activate
I looked yesterday and found out that the old mirror was not returning a module listing for 16. I think I fixed it, and perhaps that was related to the issues people were having upgrading if they were pointing towards mirror1 for their mirror server.
Matthew Fredrickson
1 Like
anyone know how i can reactivate my paid System Admin module?
looks like i have a new deployment ID
Change your deployment ID back.
not sure how to do that?
looked in admin functions and advanced settings
Sangoma portal shows license - Hardware not locked, please activate at bottom of screen
fwconsole sa activate xxxxx
If you are prevented due to a hardware lock, see: https://wiki.freepbx.org/display/FPG/How+to+Move+a+Deployment+ID+to+a+new+PBX
If you are out of resets, you can request one from a Customer Service and billing ticket: https://wiki.freepbx.org/display/FPAS/How+To+Open+A+Support+Ticket
xxxxx is the deployment ID on the Sangoma portal?
i activated the free version with the current ID - do i have to de-activate or anything before proceeding?
Maybe read what was linked?
i have read them
as i stated above i see ‘Hardware not locked, please activate’ at the bottom of the screen, not ‘Reset Hardware Lock’
i’m not sure what that means?
does it mean i have used all my resets?
So, did you ‘activate’ ?
no not yet
still not sure what i am trying to accomplish
i think i want my freepbx16 to have the same deployment ID as 15 had - i am assuming it would have if the upgrade had gone as planned
not sure that clicking the ‘activate’ button on the Sangoma portal is going to accomplish that
i am assuming that ‘fwconsole sa activate xxxxx’ with xxxxx being the original deployment ID will accomplish that??
That’s correct.
that fixed it - thanks
i think everything is back
i’ll switch over from my backup & check it out
FYI - it’s always a good idea to set your VM mac address in hyperV to static instead of dynamic. Your mac address could have changed during a reboot, which would break your licensing.
1 Like