Just a follow up on my previous posts. I installed both updates this weekend and the DAHDI did not update. I manually updated to 2.10.2 from the Digium download site and now dmesg looks much better:
wcte12xp 0000:04:08.0: PCI INT A -> GSI 38 (level, low) -> IRQ 38
wcte12xp 0000:04:08.0: Setting up global serial parameters for T1
wcte12xp 0000:04:08.0: Found a Wildcard TE121
wcte12xp 0000:04:08.0: Booting VPMADT032
wcte12xp 0000:04:08.0: VPM present and operational (Firmware version 125)
wcte12xp 0000:04:08.0: PCI INT A disabled
wcte12xp 0000:04:08.0: Freed a Wildcard TE12xP.
wcte12xp 0000:04:08.0: PCI INT A -> GSI 38 (level, low) -> IRQ 38
wcte12xp 0000:04:08.0: Setting up global serial parameters for T1
wcte12xp 0000:04:08.0: Found a Wildcard TE121
wcte12xp 0000:04:08.0: Booting VPMADT032
wcte12xp 0000:04:08.0: VPM present and operational (Firmware version 125)
wcte12xp 0000:04:08.0: Missed interrupt. Increasing latency to 5 ms in order to compensate.
wcte12xp 0000:04:08.0: VPMADT032 is non-responsive. Resetting.
wcte12xp 0000:04:08.0: VPM present and operational (Firmware version 125)
wcte12xp 0000:04:08.0: VPMADT032 is reenabled.
However, when I run dahdi_cfg --vv it still shows the same as previously except the dahdi version now shows 2.10.2 so I’m not actually sure if it is in fact echo cancelling.